Multi-Trans Metallic Gold, Silver & Bronze

Application onto Mugs

Overview: Application onto Mugs.

Description: This video explains how to transfer your prepared transfer media onto any color Mug.

Transfer Media: FOREVER Multi-Trans Metallic

Application: Mugs

Checklist

NOTE: Preheat your Heat Press before use!

Settings

Heat Transfer Press Settings:

  • MUGS
    • TEMP: 160°C (320°F)
    • TIME: 180 sec.
    • PRESSURE: HIGH Pressure
  • GLASS & METAL
    • TEMP: 160°C (320°F)
    • TIME: Open the press when the temperature above is displayed on the Digital Thermometer.
    • PRESSURE: HIGH Pressure
Application Process

APPLICATION SETTINGS: MUGS

  1. Pre-heat your Mug Press before use.
  2. Position & Fix the printed image to the mug using Heat Resistant Tape.
  3. Cover the transfer with the FOREVER Mug Press Silicone Pad.
  4. Place the mug in the press.
  5. Press by using the settings above.
  6. Cool the mug down by dipping into cold water. Make sure the transfer media is soft before peeling.
    ATTENTION: At this point, the mug is very HOT. Take precautions when moving the mug.
  7. Clean any excess particles with Isopropanol (if necessary).

APPLICATION SETTINGS: HARD SURFACES

  1. Set the temperature of the Heat Press to 200°C (392°F).
  2. Pre-heat your Heat Press before use.
  3. Position & Fix the printed image to the application using Heat Resistant Tape.
  4. Place the Sensor of the Basic Digital Thermometer between the substrate and the transfer.
  5. Cover the transfer with a Silicone Pad Speedy (2.5mm).
  6. Press together until the Basic Digital Thermometer sensor displays the temperature shown in the table above.
  7. Cool the surface down by dipping into cold water. Make sure the transfer media is soft before separating.
    ATTENTION: At this point, the application is very HOT. Be careful when moving the application.
  8. Clean any excess particles with Isopropanol (if necessary).
Related Videos